APE1086 is a low dropout positive adjustable or fixed-mode regulator with minimum of 1.5A output current capability. The product is specifically designed to provide well-regulated supply for low voltage IC applications such as high-speed bus termination and low current 3.3V logic supply. APE1086 is also well suited for other applications such as VGA cards. APE1086 is guaranteed to have <1.4V dropout at full load current making it ideal to provide well-regulated outputs of 1.25V to 5.0V with 4.7

ADP1110, Micropower Step Up/Down Switching Regulator; Adjustable and Fixed 3.3 V, 5 V, 12 V, Data Sheet, Revision 0

The ST1S06 is a step down DC-DC converter optimized for powering low-voltage digital core in HDD applications and, generally, to replace the high current linear solution when the power dissipation may cause an high heating of the application environment. It provides up to 1.5A over an input voltage range of 2.7V to 6V. An high switching frequency (1.5MHz) allows the use tiny surface-mount components: as well as the resistor divider to set the output voltage value,only an inductor and two capacit

feature 8 drawing only 150 mA with a 1.0 mA load. This part is ideal for any and SO-8 4279 all battery operated microprocessor equipment. 8 D SUFFIX ALYW Microprocessor control logic includes an active reset output RO 1 CASE 751 G with delay and a SI/SO monitor which can be used to provide an early 1 warning signal to the microprocessor of a potential impending reset signal. The use of the SI/SO monitor allows the microprocessor to 14 finish any signal processing before the reset shuts the micro

National's Comlinear CLC005 is a monolithic, high-speed cable driver designed for the ITU-T G.703 serial digital data transmission standard. The CLC005 drives 75W transmission lines (Belden 8281 or equivalent) at data rates from DC to over 622 Mbps.

The controller is an integrated circuit designed using BiCMOS-DMOS, v5 (BCD5) technology that provides complete control logic and protection for high performance, step-down DC/DC and niPOL converters.

The GE1085 is a low dropout positive adjustable or fixed-mode regulator with minimum of 3A output current capability. The product is specifically designed to provide well-regulated supply for low voltage IC applications such as high-speed bus termination and low current 3.3V logic supply. GE1085 is also well suited for other applications such as VGA cards. GE1085 is guaranteed to have <1.4V dropout at full load current making it ideal to provide well-regulated outputs of 1.25 to 5.0V with 4.

This three terminal negative adjustable voltage regulator is designed to provide 3A with higher efficiency than conventional voltage regulators. This device is designed to operate down to 1 Volt input to output differential and the dropout voltage is fully specified as a function of load current.

The ADP1110 is part of a family of step-up/step-down switching regulators that operate from an input voltage supply of as little as 1.0 V. This very low input voltage allows the ADP1110 to be used in applications that use a single cell as the primary power source.

DescriptionPM6680A is a dual step-down controller specifically designed to provide extremely high sensing technique. The constant on-time architecture assures fast load transient response and the embedded voltage feed-forward provides nearly constant switching frequency operation. An embedded integrator control loop compensates the DC voltage error due to the output ripple. Pulse skipping technique increases efficiency at frequency of 33 kHz is selectable to avoid audio noise issues. The PM6680A