Avago Technologies' MGA-632P8 is an economical, easy-to-use GaAs MMIC Low Noise Amplifier (LNA) with active bias. The LNA has low noise with excellent input return loss and high linearity achieved through the use of Avago Technologies' proprietary 0.5um GaAs Enhancement-mode pHEMT process. The LNA has an extra feature that allows a designer to adjust supply current and gain externally. Due to the high isolation between the input and output, gain can be adjusted independently through a re

This device is designed for general purpose amplifier applications at collector currents to 300mA. Sourced from process 10.

M/A-COM's AM-160 is a coupler feedback amplifier with high intercept and compression points. The use of coupler feedback minimizes noise figure and current in a high intercept ampliifer. This amplifier is packaged in a flatpack with flanges. Due to the metal flatpack the htermal rise is minimized. The ground plane on the PC board should be configured to remove heat from use where a high intercept, high reliability amplifier is required.

HS-2700RH is radiation hardened internally compensatedoperational amplifiers which employ dielectric isolation toachieve excellent DC and dynamic performance with verylow quiescent power consumption.DC performance of the amplifier input is characterized by high CMRR (106dB), low offset voltage (0.5mV), along with low bias and offset current (5.0nA and 2.5nA respectively).

The NTE1171 is a general purpose operational amplifier in an 8-Lead Metal Can type package. Advanced processing techniques make possible an order of magnitude reduction in input currents, and a redesign of the biasing circuitry reduces the temperature drift of the input current.

specifications that apply over the full operatingtemperature range, otherwise specifications are at TA = 25 C. VS = 5V, AGND = 2.5V, Gain = 1 (Digital Inputs 001), RL = 10kto midsupply point, unless otherwise noted.ELECTRICAL CHARACTERISTICSC/I GRADESH GRADEPARAMETERCONDITIONSMINTYPMAXMINTYPMAXUNITS LTC6911-1/LTC6911-2Total Supply Voltage (VS)Supply Current per ChannelVS = 2.7V, VINA = V INB = V AGNDl2.13.152.13.25mA VS = 5V, V INA = V INB = V AGNDl2.53.752.54.00mA VS = 5V, VINA = VINB = 0V, Pin

The MBC13916 is a cost-effective, high isolation amplifier fabricated with an advanced RF BiCMOS process using the SiGe:C module. It is intended to be a replacement for the MRFIC0916 and is housed in the smaller SOT-343R surface mount package. As with the MRFIC0916, this device is designed for general purpose RF applications, yet has improved high frequency gain and noise figure. On-chip bias circuitry sets the bias point while matching is accomplished off-chip, affording the maximum in applicat

The TDA7562 is a new BCD technology Quad Bridge type of car radio amplifier in Flexiwatt27V package specially intended for car radio applications. Thanks to the DMOS output stage the TDA7562 has a very low distortion allowing a clear powerful sound. This device is equipped with a full diagnostics array that communicates the status of each speaker through the I2C bus.The possibility to control the configuration and the behaviour of the device by means of the I2C bus makes TDA7562 a very flexible

The A5-5 RF amplifier is a discrete thin film hybrid design, which incorporates the use of thin film manufacturing processes for accurate performance and high reliability.

The transistor is subdivided into one group according to it DC current gain. As complementary type the NPN transistor ST 2N5088 and ST 2N5089 are recommended.