The TS4855 is a complete low power audio amplifier solution targeted at mobile phones. It integrates, into an extremely compact flip-chip package, an audio amplifier, a speaker driver, and a headset driver. The Audio Power Amplifier can deliver 1.1 W (typ.) of continuous RMS output power into an 8 ? speaker with a 1% THD+N value. To the headset driver, the amplifier can deliver 85 mW (typ.) per channel of continuous average power into stereo 32 ? bridged-tied load with 0.5% THD+N @ 5 V.

PWM current control, Logic input serial-parallel converter and current attenuation switching function.

The MSK 1900 is a high performance, high voltage, variable gain video amplifier capable of directly driving high resolution video displays. The MSK 1900 features differential inputs and a linearly adjustable gain stage with an output offset adjustment which allows it to be a versatile performer well suited for many applications. A TTL level blanking input is available to set the output to a predetermined black level independent of signal input.

DESCRIPTION Half Bridge N-ChannelPower MOSFET DriverA single input pin on the LT1158 synchronously controls two N-channel power MOSFETs in a totem pole con gura-tion. Unique adaptive protection against shoot-through currents eliminates all matching requirements for the two MOSFETs. This greatly eases the design of high ef ciency motor control and switching regulator systems.A continuous current limit loop in the LT1158 regulates short-circuit current in the top power MOSFET. Higher start-up curr

High current type (IC(MAX) = 800mA) With built-in bias resistors. Simplify circuit design Reduce a quantity of parts and manufacturing process Low VCE (sat)

The TD62382AP / AF are non?inverting transistor array which are comprised of eight Low saturation output stages and PNP input stages. This device is low level input active driver and is suitable for operation with TTL, 5 V CMOS and 5 V Microprocessor which have sink current output drivers. Applications include relay, hammer, lamp and LED display drivers

M/A-COM's AT65-0283 is a GaAs FET 5-bit digital attenuator with integral TTL driver. Step size is 0.5 dB providing a 15.5 dB total attenuation range. This device is in a SOIC-16 plastic surface mount package. The AT65-0283 is ideally suited for use where accuracy, fast speed, very low power consumption and low sosts are required.

Typically, these arrays of LEDs are required to work from a nominal 12 volt DC supply which can have a significant output voltage variation. Dimming can be used to reduce light levels or to match mixed color RGB LEDs light output. Dimming requirements are complicated by the variations present in the chromaticity of high power LEDs with LED current. Two common methods of dimming are presently used; a continuous (analog) dimming where the current in the LED is reduced in a linear manner and PWM di

DescriptionQtyJ1,J2CONNECTOR, SMA, AMP1052901-12-PCB, TACONIC, RF-35-0100-CH/CH1Q1CMPA0060005F1Notes1 The CMPA0060005F is connected to the PCB with 2.0 mil Au bond wires.2 Product Dimensions CMPA0060005FPRELIMINARY8CMPA0060005F Rev 0.Cree, Inc.4600 Silicon DriveDurham, NC 27703USA Tel: +1.919.313.5300www.cree.com/wirelessCopyright 2008 Cree, Inc. All rights reserved. The information in this document is subject to change without notice. Cree and the Cree logo are registered trademarks of Cree, In

With built-in bias resistors Simplified circuit design Reduce a quantity of parts and manufacturing process