The PPG33F-series device is a 3-bit digitally programmable pulse enerator. The width, PWA, depends on the address code (A2-A0) according to the following formula: PWA = PW0 + TINC * A where A is the address code, TINC is the incremental pulse width of the device, and PW0 is the inherent pulse width of the device. The incremental width is specified by the dash number of the device and can range from 0.5ns through 50ns, inclusively. RESET is held LOW during normal operation. When it is br

SiP42104 is an integrated H-Bridge solenoid driver and programmable output pulse width controller IC intended for digital camera micro module focus mode applications. The input pulse edge determines the output on-state for a duration programmed by an external RC time constant. Four integrated MOSFETs form the H- Bridge.

The IP1842A/IP1843A series of switching regulator control circuits contain all the functions necessary to implement off-line, current mode switching regulators, using a minimum number of external parts. Functions included are voltage reference, error amplifier, current sense comparator, oscillator, totem-pole output driver and under-voltage lockout circuitry.

NPN Silicon Power Transistors Input and Output Matched to 50? Duroid Circuit Board Easily Combined For High Power Transmitters Plated Copper Flange

Features NPN silicon microwave power transistors Common base configuration Broadband Class C operation High efficiency inter-digitized geometry Diffused emitter ballasting resistors Gold metallization system Internal input and output impedance matching Hermetic metal/ceramic package RoHS compliant Electrical Specifications: TC = 25 5C (Room Ambient ) Parameter Test Conditions Frequency Symbol Min Max Units Collector-Emitter Breakdown Voltage IC = 10mA BVCES 65 - V Collector-Emitter Leakage Curre

The ePWM peripheral is used to perform a function that is mathematically equivalent to a digital-to-analog converter (DAC). As shown in Figure 1, the effective resolution for conventionally generated PWM is a function of PWM frequency (or period) and system clock frequency.

Figure 1. Resolution Calculations for Conventionally Generated PWM

This circuit is configured in quad monostable mode of operation, which are four independent basic time delay circuits, each using a 555 type of timer. The single chip quad timer offer excellent timing and temperature tracking between the 4 separate timers. The monostable circuit is also sometimes referred to as a one-shot circuit, as it generates one fixed delay pulse every time it is triggered. In the initial state, the circuit is in the standby mode. The trigger input is at a high level, and t

The HIP6005 provides complete control and protection for a DC-DC converter optimized for high-performance microprocessor applications. It is designed to drive an N-Channel MOSFET in a standard buck topology.

The 1004MP is a COMMON BASE transistor capable of providing 4 Watts of Pulsed, RF output power in the band 960 to 1215 MHz. This transistor is specifically designed for pulsed Avionics amplifier applications. It utilizes gold metalization and low thermal resistance packaging to provide high reliability and supreme ruggedness.

NPN Silicon Microwave Power Transistor Common Base Configuration Broadband Class C Operation High Efficiency Interdigitated Geometry Diffused Emitter Ballasting Resistors Gold Metalization System Internal Input and Output Impedance Matching Hermetic-Metal/Ceramic Package