2.4Æ’"2.4mm Max.(LÆ’"W),10.5mm Max. Height, Operating temperature: "40°C to +85°C.

Continuous display of UUT, PRF, % reply and transmitter frequency and power Variable SLS and Echo Pulse Level Digital display of decoded transponder reply pulses Acceleration, velocity and range DME Modes TACAN modulation and reference bursts Two-year limited warranty

2.4Æ’"2.4mm Max.(LÆ’"W),10.5mm Max. Height, Operating temperature: "40°C to +85°C.

Read XPDR code and altitude numerically Measure transponder frequency and check for correct DME channel Measure transponder receiver sensitivity Performs all tests required by the revised Federal Aviation Regulations (91.177 and 43 Appendix F) Two-year limited warranty

2.4Æ’"2.4mm Max.(LÆ’"W),10.5mm Max. Height, Operating temperature: "40°C to +85°C.

Transponder Test Set Modes 1, 2, 3/A, C, 4, S Interrogator Test Set Modes 1, 2, 3/A, C, 4, S, TCAS, ETCAS Can be upgraded to Mode 5 testing capability (planned) Hand-held, Battery Powered and Lightweight (under 11 lb) One piece, 3-button point and shoot Go/No-Go Operation Self-diagnostic with extended calibration cycle Automated MTL measurement

The device has an on-chip rectification circuit that convertsthe incoming rf signal to DC power feeding VDD. There isalso an on-chip data modulator, which works in conjunctionwith the rectifier. The time base is extracted by an on-chipRF clock extractor. High voltage protection across the coilinputs is provided internally. The energy is stored oncapacitance on chip due to low internal power consumption.The device has an on-chip resonance capacitor connectedbetween the COIL1 and COIL2 pads. These

The TK5551 is a completely programmable R/W transponder which implements all important functions for identification systems, including anti-collision (e.g., 10 tran-sponders in < 500 ms depending on the application). It allows the contactless reading and writing of data which are transmitted bi-directionally between a read/write base station and the transponder. It is a plastic-packaged device which accommodates the IDIC e5551 and also the antenna realized as an LC-circuit. No additional ext

The device has an on-chip rectification circuit that convertsthe incoming rf signal to DC power feeding VDD. There isalso an on-chip data modulator which works in conjunctionwith the rectifier. The time base is extracted by an on-chipRF clock extractor. High voltage protection across the coilinputs is provided internally. The energy is stored oncapacitance on chip due to low internal power consumption.The device has an on-chip resonance capacitor connectedbetween the COIL1 and COIL2 pads. These

The TK5552 is a complete programmable R/W transponder that implements all impor-tant functions for identification systems. It allows the contactless reading (uplink) and writing (downlink) of data which are transmitted bi-directionally between a read/write base station and the transponder. It is a plastic cube device which accommodates the IDIC transponder IC and the antenna is realized as an LC circuit. No additional exter- nal power supply is necessary for the transponder because it receives p