The MAS9179 AM-Receiver chip is a highly sensitive, simple to use AM receiver specially intended to receive time signals in the frequency range from 40 kHz to 100 kHz. Only a few external components are required for time signal receiving.

MAS9124 is a low dropout voltage regulator with very low output noise, high PSRR and small output capacitance requirement.

MAS6281 is an integrated circuit well suited to make fundamental crystal oscillator (XO): only one additional component, a crystal is needed.

The MAS1016 AM-Receiver chip is a highly sensitive, simple to use AM receiver specially intended to receive time signals in the frequency range from 40 kHz to 100 kHz. There are only a few external components needed.

MAS9285 is capacitive digital to analog converter integrated circuit well suited to make initial offset trimming of the crystal oscillator. The trimming is done by a serial bus and the calibration information is stored in an internal PROM.

The MAS9180 AM-Receiver chip is a highly sensitive, simple to use AM receiver specially intended to receive time signals in the frequency range from 40 kHz to 100 kHz.

The MAS9125 is a voltage regulator IC with five 2.8 V ultra low noise LDO regulators. Each regulator has its own independent enable/disable control pin. Additionally, all the outputs can be turned off by using a common control pin, which overrides regulator specific control pins.

The MAS6282 is an integrated circuit well suited to build VCTCXO for mobile communication. Temperature calibration is achieved in three calibration temperatures only.

The Cellular Baseband evaluation board includes MAS9191A (Audio/Data Processor), MAS9129 (Battery Management) and MS8323 (VCTCXO) ICs with all needed external components and software.