descriptions of characteristics of performance which in case of actual use do not always apply as described or which may change as a result of further development of the products. An obligation to provide the respective characteristics shall only exist if expressly agreed in the terms of contract.www.siemens.com/wallace-tiernanUSA: +1 856 507 9000wtus.water@siemens.comFor detailled information about the SFC and MFC systems please see:SFC Series WT.050.590.000.PSMFC System WT.050.580.000.BR Measuring cell DEPOLOX 5 Measuring system Potentiostatic 3-electrode system Measuring ranges 70, 100, 200, 1000 A Electrolyte Potassium chloride solution, 3 mol up to 500 g/l: 1 g/l; up to 5 mg/l: 0,01 mg/l; Resolution up to 50 mg/l: 0,1 mg/l; up to 200 mg/l: 1 mg/l Typical output signal approx. 20 A/mg/l free chlorine Response time T90 < 20 sec. Conductivitymin 200 S/cm Enclosure Sensor connection IP 66, designed to meet NEMA 4X Temperature compensation yes, with Pt 1000 (0 - 50 C /32 - 122 F) yes, FeaturesThe DEPOLOX 5 flow cell consists of a 3-electrode system utilizing a bare-electrode design which pro- vides a quick response time (90 % change < 20 sec.) with high accuracy ( 2 % F.S.) when compared to membrane sensor technology. Hydrodynamic grit cleaning of the electrode surfaces maintains sensi- tivity to extend the intervals between calibrations. Zero point calibration is not necessary. A sample with a constant pH is required, however, the addition of a measurement with the suitable electronic package. An integral multi-sensor provides a PT 1000 tempe -rature measurement and monitors sample flow to provide a loss-of-flow alarm contact. The flow cell is supplied with a 1 m (3.3 ft.) screened coaxial cable. Up to three additional sensors can be fitted into the flow cell for measuring other water parameters. DEPOLOX 5 flow module with plug-in cardUtilizing plug and play technology allows the SFC or MFC controller to automatically recognize the sensor card and provide the corre Wallace & Tiernan Analyzers/Controll