feature, andselect the number of banks that you want to use. Define the start and end address of the bank area tomatch the memory map that you want to use.Figure 2. Setting the Project / Options for Target / Target Screen3/13AN1816 - APPLICATION NOTEThen, you can set up the options for each of the source code modules that you want to have in the bankedFlash memory, as shown in Figure 3, by right-clicking on the source code file name, and selecting Op-tions.You will need to select the page or code bank in which this specific source code is to be located. If you donot select a code page, the compiler will default to a page where it can be fitted. To specify a specific page,select the Code Bank, pull down and select the bank page number. Common places the code in the low-er, common code area.Figure 3. Setting the Options for Each Module of Banked Flash MemoryAN1816 - APPLICATION NOTE4/13EDITS TO THE KEIL BANKING START-UP FILEIn the L51_bank.a51 file you should make the following adjustmen Specifications mentioned in this publication are subjectto change without notice. This publication supersedes and replaces all information previously supplied. STMicroelectronics products are notauthorized for use as critical components in life support devices or systems without express written approval of STMicroelectronics.The ST logo is a registered trademark of STMicroelectronics.All other names are the property of their respective owners 2004 STMicroelectronics - All rights reservedSTMicroelectronics GROUP OF COMPANIESAustralia - Belgium - Brazil - Canada - China - Czech Republic - Finland - France - Germany - Hong Kong - India - Israel - Italy - Japan - Malaysia - Malta - Morocco - Singapore - Spain - Sweden - Switzerland - United Kingdom - United Stateswww.st.comMay 20041/13AN1816APPLICATION NOTEConfiguring the Keil Compiler and PSDsoft to HandleMulti-Paged Memory in PSD Application SoftwarePSD devices have an 8032 core, and an extremely large array of Flash memory bigger than t AN1816 - APPLICATION NOTE2/13Figure 1 is an ex