DescriptionThe LD1086 is a low drop voltage regulator able to provide up to 1.5 A of output current. Dropout is guaranteed at a maximum of 1.2 V at the maximum output current, decreasing at lower loads. The LD1086 is pin to pin compatible with the older 3-terminal adjustable regulators, but has better performances in term of drop and output tolerance.A 2.85 V output version is suitable for SCSI-2 active termination. Unlike PNP regulators, where a part of the output current is wasted as quiescent current, the LD1086 quiescent current flows intothe load, so increase efficiency. Only a 10 F minimum capacitor is need for stability. The device is supplied in TO-220, D2PAK, D2PAK/A and DPAK. On chip trimming allows the regulator to reach a very tight output voltage tolerance, within 1 % at 25 C.The LD1086 is available as Automotive Grade in TO-220 and DPAK packages, for the option of adjustable output voltage whose commercial Part Numbers are shown in the Table17 (order codes). These devices Features Typical dropout 1.3 V at 1.5 AThree terminal adjustable or fixed output voltage 1.5 V, 1.8 V, 2.5 V, 3.3 V, 5 V, 12 VAutomotive Grade product: adjustable VOUT only in TO-220 and DPAK packagesGuaranteed output current up to 1.5AOutput tolerance 1 % at 25 C and 2 % in full temperature rangeInternal power and thermal limitWide operating temperature range -40 C to 125 CPackage available: TO-220, D2PAK, D2 PAK/A, DPAK Pinout compatibility with standard adjustable VREG DescriptionThe LD1086 is a low drop voltage regulator able to provide up to 1.5 A of output current. Dropout is guaranteed at a maximum of 1.2 V at the maximum output current, decreasing at lower loads. The LD1086 is pin to pin compatible with the older 3-terminal adjustable regulators, but has better performances in term of drop and output tolerance.A 2.85 V output version is suitable for SCSI-2 active termination. Unlike PNP regulators, where a part of the output current is wasted as quiescent current, the LD1086 qu specification AEC-Q100 of the Automotive marke