DescriptionThis board is a general-purpose developmant platform for all applications based on the TS4962M mono class D audio amplifier. The TS4962M is a monolithic fully-differential input/output class D power amplifier. It also includes a common-mode feedback loop that controls the output bias value to average it at VCC/2 for any DC common mode input voltage. This allows the device to always have a maximum output voltage swing, and consequently maximizes the output power. Moreover, as the load is connected differentially compared to a single-ended topology, the output is four times higher for the same power supply voltage.STEVAL-CCA001V1www.st.comBoard schematicSTEVAL-CCA001V12/4 1 Board schematicFigure 1.SchemeIn-StdbyIn+Out-Out+Vcc 4512 10 38 36GNDInternal BiasPWMOutputBridge HOscillator 150k150k +- 300k U1TS4962 Flip-Chip to DIP AdapterGNDVcc R1 150k R2 150k C2 100nF C3 100nFCn3Cn6Cn2 123Cn1 + J1GNDGNDVccVcc + C12.2uF/10VGNDCn4 + J2Cn5 + J3Positive OutputNegative OutputPositive Inp Features Operating from Vcc = 2.4 V to 5.5 VUltra low power consumption in standby mode (10 nA)63 dB PSRR @ 217 Hz in grounded mode (average = 2 V/V)Low pop and clickFast startup time (5 ms)Module gain set at 2 V/VThermal and short circuit protectionDescriptionThis board is a general-purpose developmant platform for all applications based on the TS4962M mono class D audio amplifier. The TS4962M is a monolithic fully-differential input/output class D power amplifier. It also includes a common-mode feedback loop that controls the output bias value to average it at VCC/2 for any DC common mode input voltage. This allows the device to always have a maximum output voltage swing, and consequently maximizes the output power. Moreover, as the load is connected differentially compared to a single-ended topology, the output is four times higher for the same power supply voltage.STEVAL-CCA001V1www.st.comBoard schematicSTEVAL-CCA001V12/4 1 Board schematicFigure 1.SchemeIn-StdbyIn+Out-Out+Vcc 4512 Data BriefFor further information contact your